One for All URC 3050 User Manual page 2

Step 1:
Installing the Batteries
®
One For All So Easy 3 Device
Your
alkaline batteries. To install the batteries:
1
On the back of the
Device
, push down on the tab and lift the
cover off.
Match the batteries to the + and - marks inside
2
the battery case, then insert the batteries.
3 Press the battery cover back into place.
4 Test the unit by pressing POWER. The red
light (LED) should blink once.
Note: Removing the batteries for more than 30 minutes will require you to
reprogram the remote control.
Step 2:
Looking Up Your Electronic Device Code
Look at your Electronic Device to find out the brand name and
1
write it in the space below:
TV ________________________
VCR _______________________
Cable _______________________
Find your Device brand in the listing on the
2
Set-Up Codes
reverse side of these instructions. The most
popular codes are listed first. Write your codes
RCA 1213
Sony 1111
here:
1st TV code
2nd TV code
3rd TV code
1st VCR code
2nd VCR code
3rd VCR code
1st Cable code
2nd Cable code
3rd Cable Code
You will need o ne of these codes to program your One For All
Easy 3 Device remote.
needs two (2) new AAA
®
One For All So Easy 3
®
So
Step 3:
Setting Up Your Devices
1
Turn on your TV, VCR or Cable Box, depending on the
device you are programming.
Press TV* and release. Press and hold SETUP
2
until the One For All
light blinks twice. Release SETUP.
+
* Note: When setting up your VCR and/or Cable Box,
substitute the appropriate device key (VCR or CBL).
3
Using the example
shown on the
right, enter the
first four-digit
code you wrote
down for the
device you are
setting up. (See
"Looking Up Your
Electronic Device
Code".) If you put
in the code
correctly, the red
light will blink
twice.
TV Set Up
4
Aim the One For All
TV and press POWER. Your TV should turn off.
If it doesn't, repeat Steps 2-4, trying each code listed
for your brand until you find the one that operates
your TV.
VCR Set Up
Aim the One For All
VCR and press POWER. Your VCR should turn
or
off. If it doesn't, repeat Steps 2-4, trying each code
listed for your brand until you find the one that
operates your VCR. If your original VCR remote
did not have a POWER key, put a tape in your
VCR and press PLAY on the One For All
Easy3 Device.
Cable Set Up
Aim the One For All
or
Cable Box and press POWER. Your Cable Box
should turn off. If it doesn't, repeat Steps 2-4, trying
each code listed for your brand until you find the
one that operates your Cable Box. If your original
Cable Box remote did not have a "ON" key, Use
CH + on the One For All
turn your Cable Box on.
®
So Easy 3 Device's red
How to Enter Codes
If your TV Press
code is:
1
2
3
4
®
So Easy3 Device at your
®
So Easy3 Device at your
®
So
®
So Easy 3 Device at your
®
So Easy 3 Device to