Using The Motorized Floor Nozzle; Using The Dust-Away; Above Floor Cleaning - Shark HV324Q Instructions Manual

USING THE MOTORIZED FLOOR NOZZLE

This vacuum has a 2-speed POWER slider switch, optimized for bare floor, delicate area rug and carpet cleaning.
The floor nozzle has headlights that illuminate the floor surface. The lights turn on in either speed setting.
STEP 1
1 Plug the unit in and pull it back. 2 Slide the POWER switch to the first position to clean
bare floor surfaces and delicate area rugs. The brush
roll will spin slowly to help with debris pick-up.

USING THE DUST-AWAY

™ HARD FLOOR ATTACHMENT
NOTE: This vacuum does not stand up on its own, so when taking a break, rest it against furniture, on the wall, or lay it flat on the floor.
6
STEP 2 STEP 3
3 Slide the POWER switch to the second position to
clean carpets. The brush roll will spin faster to help
pick up debris below the surface.
1 Slip two tabs between the nozzle and the duster base and attach them to the front
fasteners. Then pull the other two tabs tightly around to the back fasteners. Ensure that
the pad is flat against the bottom surface and tightly secured.
2 Slide the POWER switch to the first position and use the Dust-Away
Attachment to clean hard floor surfaces. Do not use to clean damp floors or wet/sticky
messes. Only use pads provided by Shark , which are designed to work with the Dust-
®
Away ™ Hard Floor Attachment.
MICROFIBER PAD CARE
Machine or hand wash the pads separately in warm water with liquid detergent.
Do not use bleach or fabric softeners as they may damage or leave a coating that will
reduce the cleaning performance of the pads.
Tumble dry low or line dry to extend the life of the microfiber fabric.
For best results, we recommend replacing your microfiber pads every 3 to 4 months.
w w w . s h a r k r o c k e t . c o m

ABOVE FLOOR CLEANING

This vacuum has the reach to clean above floors or in tight spaces by using the wand.
It's also a convenient handheld vacuum when using it without the wand.
STEP 1
1 Stand the vacuum upright. Step on the foot pedal and
pull the wand up to disconnect from the floor nozzle.
Attach desired cleaning accessory.
™ Hard Floor
NOTE: Both power settings provide the same suction
power.
Videos of helpful tips on how to use accessories can be found in the Support section on www.sharkrocket.com
STEP 2
Wand
Release
2 Press the WAND RELEASE button on the top of the TIP: You can attach the handheld vacuum directly to
wand to disconnect it from the handheld portion. the floor nozzle for convenient cleaning on stairs.
Attach desired cleaning accessory. The LED light in
the handheld vacuum turns on automatically when
the power is on.
1. 8 0 0 . 7 9 8 . 7 3 9 8 7