Kenwood DNX4280BT Service Manual page 20

DNX4280BT/5180/5280BT/5380/5380M
/5380BT/5580BT/6040EX/6180/6480BT/6980
Key Specifi cation
UP : Mute Level Up
DW : Mute Level Down
■Write : Write to the nonvolatile memory.
Cancel : Transfer to Service screen.
Return : Transfer to Service screen.
∗ Background color will be blue when "Write OK" is dis-
played.
∗ Background color will be red when "Write NG" is dis-
played.
∗ When adjusting the Tuner Mute Level, perform with the
following condition.
Set the frequency before transferring to the Tuner Mute
Level adjustment screen. (Even after completing adjust-
ment, the frequency remains the same.)
Audio Source : Tuner
LOUD : OFF
Volume : Step30
Frequency : Default value of the set
2.2.3.7 DVS8700 Adjustment screen
This is to display DVS-8700 Servo Adjustment screen.
The DVS8700 Adjustment screen is displayed in Figure
2.2.3.7.
DVS8700 Adjust
Offset Cancel Inner Limit
Focus Height
Cancel
Figure 2.2.3.7 DVS-8700 Adjustment screen
Key Specifi cation
Offset Cancel
: Start the Offset Cancel Adjustment.
Note: Active only when there is no disc and not
adjusting.
Inner Limit : Start the Inner Limit Adjustment.
Note: Active only when there is no disc and not
adjusting.
Focus Height
: Start the Focus Height Adjustment.
Note: Active only when there is disc, not ad-
justing, and mechanism power off.
Cancel : Transfer to Service screen.
Return : Transfer to the DVS8700 Adjustment screen.
(left screen in Figure 2.2.3.7)
20
TEST MODE
DVS8700 Adjust
Adjust OK/NG
Return
∗ Background color will be blue when "Adjust OK" is dis-
played.
∗ Background color will be red when "Adjust NG" is dis-
played.
2.2.4 Touch Adjust screen
Fine-tune the variations of touch feeling in of each set.
Touch 2 markers one by one, and the adjustment is com-
pleted when the "Write OK" is shown on the screen.
If the "Write NG" is shown, transfer to the Test mode again
to re-start the adjustment from the fi rst step.
The Touch Adjustment screen is shown in Figure 2.2.4.
Touch Adjust
2-point
being input
1-point Cancel
being input
Figure 2.2.4 Touch Adjust screen
Key Specifi cation
Cancel : Transfer to Test Mode Main screen.
Return : Transfer to Test Mode Main screen.
∗ Background color will be blue when "Write OK" is dis-
played.
∗ Background color will be red when "Write NG" is dis-
played.
2.2.5 Illumi Adjust screen
This screen is used to adjust the white color of the key il-
lumi.
This test is not performed for the models with " " listed in
the Electrostatic touch column of Table 1.2.1.
The Illumi Adjustment screen is displayed in Figure 2.2.5.
Illumination Adjust
Table9 Table3 Table5 Table7
Table10 Table10 Table4 Table6
Table8 Table4 Table6 Table8
Table2 Table2 Table2
Table1
Cancel Next
Illumination Adjust
Write OK/NG
Return
Figure 2.2.5 Illumi Adjustment screen
Touch Adjust
Write OK/NG
Return
Illumination Adjust
Step1 Step1 Step1 Step1
Step2
Step2 Step2 Step2
Step3 Step3 Step3 Step3
Step4 Step4
Step0
Cancel RGB compensation value Next
Illumination Adjust
Adjustment value
Down Up
Cancel Next