Servicing The Fuses; Drive System Maintenance; Checking The Seat Belt; Checking The Rollover Protection System (Rops) Knobs - Toro 74901 Operator's Manual

Servicing the Fuses

The electrical system is protected by fuses. It requires
no maintenance, however, if a fuse blows check the
component/circuit for a malfunction or short.
1. The fuses are located on right hand console next to
the seat (Figure 60).
2. To replace the fuses, pull out on the fuse to remove it.
3. Install a new fuse (Figure 60).
Figure 60
1. Optional
accesory—15 amp
2. Charge—25 amp
3. PTO—10 amp
4. Main—25 amp
5. Console
Drive System
Maintenance

Checking the Seat Belt

Service Interval: Before each use or daily
Visually inspect seat belt for wear, cuts, and proper operation
of retractor and buckle. Replace before operating if damaged.
Checking the Rollover
Protection System (ROPS)
Knobs
Service Interval: Before each use or daily
WARNING
To avoid injury or death from rollover: keep the roll
bar in the fully raised locked position and use the
seat belt.
Ensure the seat is secured to the machine.
Check that both the mounting hardware and the knobs are in
good working condition. Make sure that the knobs are fully
engaged with the ROPS in the raised position. The upper
hoop of the roll bar may need to be pushed forward or pulled
rearward to get both knobs fully engaged (Figure 61).
44