Operating the Throttle
The throttle control can be moved between Fast and Slow
positions (Figure 15).
Always use the Fast position when turning on the mower
deck with the blade-control switch (PTO).
Operating the Choke
Use the choke to start a cold engine.
1. If the engine is cold, use the choke to start the engine.
2. Pull up on the choke knob to engage the choke before
using the ignition switch (Figure 16).
3. Push down on the choke to disengage the choke after
the engine has started (Figure 16).
1
2
1. On position
G008946
Figure 15
G008959
Figure 16
2. Off position
Operating the Ignition Switch
1. Turn the ignition key to the Start position (Figure 17).
Note: When the engines starts, release the key.
Important: Do not engage starter for more than 5
seconds at a time. If the engine fails to start allow
a 15-second cool-down period between attempts.
Failure to follow these instructions can burn out
the starter motor.
Note: Additional starting cycles may be required
when starting the engine for the first time after the fuel
system has been without fuel completely.
2. Turn the ignition key to stop to stop the engine.
Using the Fuel Shutoff Valve
The fuel shut-off valve is located under the seat. Move the
seat forward to access it.
Close the fuel shut-off valve for transport, maintenance, and
storage.
Ensure the fuel shut-off valve is open when starting the
engine.
1
2
G008948
1. On position
20
G008947
Figure 17
Figure 18
2. Off position