Logout; Ping - D-Link DXS-1210 Series User Manual

5 Command Line Interface
Restrictions
Example usage:
To configure the IP interface System:
DXS-1210-12TC> config ipif 1 ipaddress 10.90.90.98 255.0.0.0
Success.
DXS-1210-12TC>

logout

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To terminate the current user's console session:
DXS-1210-12TC> logout

ping

Purpose
Syntax
Description
Parameters
information using the traditional format (for
example,10.1.2.3/255.0.0.0)
dhcp − Allows the selection of the DHCP protocol for the
assignment of an IP address to the Switch's System IP interface.
ipv6address <ip6_addr> − Use this parameter to statically assign
an IPv6address to this interface. This address should define a
host address and a network prefix length. Multiple IPv6
addresses can be configured for a single IP interface. Ex:
3ffe:501:ffff:100::1/64. The /64 represents the prefix length of the
IPv6 addresses.
dhcpv6_client <enable | disable> − Specify the DHCPv6 client to
be disabled or enabled.
Only Administrator or operator-level users can issue this
command.
To log out a user from the Switch's console.
logout
The logout command terminates the current user's session on
the Switch's console.
None.
None.
NOTE: Save your configuration changes before
logging out.
To test the connectivity between network devices.
ping [<ipv4_addr> | <ipv6_addr>] [size <integer 1-60000>]
[timeout <time_out 1-100>] [repeat <integer 0-255>]
The ping command checks if another IP address is reachable on
the network. You can ping the IPv4 address connected to through
the managed VLAN (VLAN 1 by default), as long as there is a
physical path between the switch and the target IPv4 equipment.
By default, Switch sends five pings to the target IP.
<ipv4_addr> - The IPv4 address of the host.
1 0 3
1 0 3
D-Link DXS-1210 Series User Manual