Using The Remote Control; Installing The Unit; Plugging In - Pioneer XW-NAS5 Operating Instructions Manual

01 Before you start
• Remove the battery if the unit isn't going to
be used for a month or more.
• When disposing of used batteries, please
comply with governmental regulations or
environmental public instruction's rules
that apply in your country or area.
• WARNING
Do not use or store batteries in direct
sunlight or other excessively hot place,
such as inside a car or near a heater. This
can cause batteries to leak, overheat,
explode or catch fire. It can also reduce the
life or performance of batteries.

Using the remote control

The remote has a range of about 7 m at an
angle of about 30º from the remote sensor.
Keep in mind the following when using the
remote control:
• Make sure that there are no obstacles
between the remote and the remote sensor
on the unit.
• Remote operation may become unreliable
if strong sunlight or fluorescent light is
shining on the unit's remote sensor.
• Remote controllers for different devices
can interfere with each other. Avoid using
remotes for other equipment located close
to this unit.
• Replace the batteries when you notice a fall
off in the operating range of the remote.

Installing the unit

• When installing this unit, make sure to put
it on a level and stable surface.
Don't install it on the following places:
– on a color TV (the screen may distort)
– near a cassette deck (or close to a device that
gives off a magnetic field). This may interfere
with the sound.
– in direct sunlight
– in damp or wet areas
6
En
– in extremely hot or cold areas
– in places where there is vibration or other
movement
– in places that are very dusty
– in places that have hot fumes or oils (such as
a kitchen)

Plugging in

After you've finished making all connections,
plug the unit into an AC outlet. The type of cord
which can be used depends on the power
voltage in each region or country. Please make
sure you use the correct cord due to the
possibility of fire or other hazard if used
incorrectly (see below).
AC power cord use
Region
For Taiwan exclusively
Caution
For use in Taiwan only. In
other areas, please do
not use.
For Australian and New
Zealand exclusively
For Others
1 Plug the supplied power cord into the AC
IN socket on the back of the unit.
2 Plug the other end into a power outlet.
Important
• Before making or changing any
connections, switch off the power and
disconnect the power cord from the AC
outlet.
Plug type
Taiwanese two-pin flat-
bladed plug
AS 3112 flat two-pin plug
European two-pin plug