Remote Control - Pioneer HTP-SB300 Operating Instructions Manual

Controls and displays

Remote control

SYSTEM SYSTEM
1
2
INPUT
HDMI1 HDMI2
5
OPTICAL COAXIAL
STANDARD ADV SURR
7
AUTO/ STEREO/
DIRECT A.L.C.
LISTENING MODE
9
ENTER
10
12
14
SURROUND SYSTEM
 SYSTEM
1
Switches the system between standby and on.
2
Switches the remote to control the system.
Also use to adjust the Audio parameters
(page 23).
3
INPUT SOURCE
4
TV CONTROL
6
CH
INPUT
TV CODE
VOL
DIMMER
BD MENU
8
11
13
MUTE
DISPLAY
15
CH
CH
16
ENTER
3 INPUT SELECT
Use to select the input source.
SOURCE
4
Press to turn on/off other components
connected to the system (see page 29 for more
on this).
5 INPUT SELECT buttons
Use to select the input source. Switch the
remote control to operate any other components
allocated to the selected buttons (see
Controlling the rest of your system on page 26).
6 TV CONTROL buttons
These buttons are dedicated to control the TV
assigned to the
only have one TV to hook up to this system
assign it to the
for more on this).

Use to turn on/off the power of the TV.
INPUT
Use to select the TV input signal.
Press to select control of TV. Also use to
input a preset code allocated to the TV
CONTROL button.
CH +/–
Use to select channels.
VOL +/–
Use to adjust the volume on your TV.
7 Listening mode buttons
AUTO/DIRECT
Switches between Auto surround mode
(Auto playback on page 20) and Stream
Direct playback. Stream Direct playback
bypasses the tone controls for the most
accurate reproduction of a source
(page 22).
button. Thus if you
button (see page 28
03
17
En