GE JKP46G Use And Care Manual page 25

Questions?
Use This Problem Solver
PROBLEM
OVEN WILL
OVEN LIGHT
DOES NUf WORK
ELECTRONIC
WILL NOT' WORK
ELECTRONIC
DISPLAY PANEL
GOES BLANK
OR BLINKS
FOOD DOES N(YI'
BROIL PROPERLY
FOOD DOES NOT
ROAST PROPERLY
FOOD DOES NOI'
BAKE PROPERLY
POSSIBLE CAUSE AND REMEDY
circuit fhse, a tripped oven circuit breaker, the main fine or the main circuit break
depending on nature of the power supply, If a circuit breaker is involved, reset it. 1
control box uses fi.wes, the oven fuse (a cartridge-type) should be changed BUT O
BY SOMEONE FAMILIAR WITH ELECTRICAL CIRCUITS. If after doing on[
these procedures, the fuse blws or circuit breaker trips again, call for service.
management to perform this check before calling for service.
Oven controls not properly set.
Door left in locked position after cleaning.
Light bulb is loose or bulb is burned out.
Clocks not set. Touch CLOCK pad and enter time on both display panels.
interference signals on the main power line. Disconnect your oven at the main t%s
circuit breaker panel. Wait one minute and reconnect power. Reset clock on both
display panels.
. If using a lower broil rate, the correct setting from LO to HI was not touched
after BROIL.
Probe not fully inserted into the oven receptacle or fbod when using FOOD TEMP
Improper shelf position is being used.
Food is being cooked on a hot pan.
Aluminum foil used on tie broil rack has not been fitted properly and slit.
BAKE and START pads not touched.
. Oven temperature not set correctly. Incorrect number pads touched.
. Probe not fi.dly inserted into the oven receptacle or fdod when using FOOD TEMP
Roasting pan is too small.
Improper cookware is being used.
. A foil tent was not used when needed to slow down browning.
BAKE and START pads not touched.
. Oven shelf is not level.
. Temperature setting is incorrect.
of
25