Dimplex DF2608 Owner's Manual page 14

Maintenance
Figure 7
Log Set
Assembly
the number of times you need
to open the unit to replace light
bulbs. Care must be taken when
removing the Log set assembly
as it contains LED's and wires
(DF2608 only).
1. slide fireplace out of mantel.
2. Lay unit on it's back for safe
removal of front glass.
3. Remove three (3) Phillips
screws from the right side of
trim.
4. remove trim.
5. Slide glass to right side of
fireplace to remove (Figure
7).
6. Pull the front edge of the
plastic ember bed or plastic
grate up and forward until the
rear tab releases from the
ledge located at the bottom of
the mirror (Figure 8).
!
IMPORTANT: Only handle
14
Trim
Front
Glass
Figure 8
Back
Ledge
Rear
Tab
side section
the log set assembly by the
ember bed or plastic grate.
!
NOTE: Log set assembly fits
tightly into firebox, some force
may be necessary to remove.
7. Set log set assembly in front
of fireplace.
8. remove flicker rod by pulling
rod to the right, towards
the flicker motor. Bend the
flicker rod enough to clear the
bracket on the left, lift out and
pull flicker rod off of flicker
motor shaft (Figure 9).
9. Remove four (4) Phillips
screws (two (2) per side)
which attach light filter
bracket for easier access to
light bulbs (Figure 9).
10. unscrew bulbs counter
clockwise to remove.
11. Insert new bulbs and screw in
Log
Ember Bed
Front
Edge
www.dimplex.com