Overview; Special Product Features; Start Of Operation; Side Handle Installation - Metabo UHE 22 Multi Operating Instructions Manual

6020.book Seite 11 Donnerstag, 25. Juli 2002 1:34 13

5 Overview

See page 3 (please unfold).
1 Keyless chuck
2 SDS chuck
3 Tool lock
4 Keyless chuck sleeve
5 Chuck lock
6 Spindle
7 Depth stop
8 Speed preselection wheel
9 Electronic signal indicator
10 Rotation selector switch
11 Lock button
12 Trigger
13 Control knob
14 Stop
15 Side handle

6 Special Product Features

Exchangeable chuck
With a simple operation and without the need for
extra tools the SDS chuck is exchanged against
the keyless chuck.
Single-knob control
Gears and operating modes (drilling, hammer
drilling, chiselling) are selected at actuating one
single control knob.
Rotary stop:
By turning the rotation off chiselling can be done.
Metabo S-automatic safety clutch:
If the insertion tool jams or hooks, the power flow
to the engine will be restricted. Because of the high
power which then arises, always hold the machine
with both hands on the handles, stand safely, and
concentrate on your work.
Cut-out brushes, with wearing indication on
machines with VTC electronics (UHE 28 Multi):
A LED warns before the carbon brushes are
completely worn. If the brushes are worn
completely the machine switches off
automatically.
Restart protection and overload protection
indicator on machines with VTC electronics
(UHE 28 Multi)
The restart protection prevents the machine from
being unintentionally started when it is plugged in
again or when power is restored after a power
failure.
The overload protection indicator warns of an
impending overload.

7 Start of Operation

Before plugging in check to see that the
rated mains voltage and mains
frequency, as stated on the rating label,
match with your power supply.
7.1

Side handle installation

For safety reasons, always use the side
handle supplied.
Open the clamping ring by turning the side handle
(15) counter-clockwise. Place the side handle onto
the machine's collar. Insert the depth stop (7).
Tighten the side handle in the required angle
depending on the task at hand.

8 Use

8.1

Depth Stop Setting

Loosen the side handle (15). Set depth stop (7) to
the desired drilling depth and retighten the side
handle.
8.2

Switching on/off

To start the machine, press the trigger (12).
The speed can be changed at the trigger.
The electronic soft start continuously accelerates
the machine up to the pre-selected speed
(machines with VTC electronics UHE 28 Multi
only).
For continuous operation the trigger can be locked
with the lock button (11). To stop the machine,
press the trigger again.
If switched on continuously, the machine
continues running if it is jerked out of
your hands. Therefore, always hold the
machine with both hands on the handles, stand
safely, and concentrate on your work.
8.3

Speed preselection

Depending on the application, the optimum speed
is preset with the pre-selector wheel (8).
ENGLISH
ENG
11