Installation - Alpine INE-W990BT Quick Reference Manual

Installation

•
When making connections to the vehicle's electrical
system, be aware of the factory installed components
(e.g. on-board computer). Do not tap into these leads
to provide power for this unit. When connecting the
INE-W990BT to the fuse box, make sure the fuse for the
intended circuit of the INE-W990BT has the appropriate
amperage. Failure to do so may result in damage to the
unit and/or the vehicle. When in doubt, consult your
Alpine dealer.
1
Install at an angle between horizontal
and 30°. Note that installing at an angle
outside of this range will result in a loss of
performance and possibly damage.
0 - 30°
2
Mounting the GPS Antenna inside the
vehicle.
1 Clean the mounting location.
2 Put on the GPS Antenna mounting plate.
3 Mount the GPS Antenna.
Antenna mounting plate
• Mount the GPS Antenna on a flat plane of the
dash board or rear tray.
• Some thermal reflection type or thermal
absorption type glass may interrupt high
frequency waves. If reception is poor with the
antenna installed inside the car, try to mount the
antenna outside the car.
• Make sure the GPS Antenna is not covered
(obstructed) by any metallic surface or object.
Owner's manual
3
Mounting the Microphone.
For safe use, make sure of the following:
•
•
•
When you speak into the microphone, you should
not have to change your driving posture. This may
cause a distraction, taking your attention away
from safely driving your vehicle. Carefully consider
direction and distance while mounting the
microphone. Confirm that the driver's voice can be
easily picked up at the selected location.
GPS Antenna
location is stable and firm.
driver's view and operations are not obstructed.
microphone is located where the driver's voice
can be easily picked up (on the sun visor, etc.).
Microphone
Cable clamp
(Sold separately)
Installation
13
-EN