Table of Contents
Advertisement
•
Pull back the lock collar of the nozzle adapter and
push the adapter onto the deck wash nozzle at
the left end of the 42" mower deck, or onto one of
the deck wash nozzles at either end of the 50"
mower deck. Release the lock collar to lock the
adapter on the nozzle. See Figure 34.
42 INCH DECK SHOWN
Nozzle
Adapter
Adapter
Lock Collar
Figure 34
•
Turn on the water supply.
•
From the tractor operator's seat, start the engine
and engage the PTO. Allow to run as needed.
Disengage the PTO and stop the engine.
•
Turn off the water supply.
•
Pull back the lock collar of the nozzle adapter to
disconnect the adapter from the nozzle.
•
50" Deck ONLY - Repeat the previous steps to
clean the deck using the nozzle at the other end
of the deck.
Cleaning the Spindle Pulleys
Once a month remove any accumulation of grass
clippings from around the spindle pulleys and V-belt.
Clean more often when mowing tall, dry grass.
Mower Blade Care
WARNING: Before performing any main-
tenance, place the PTO switch in the
"OFF" position, engage the parking
brake lever, turn the ignition key to the
"OFF" position and remove the key from
the switch. When servicing the mower
deck, be careful not to cut yourself on
the sharpened blades.
Pull Lock
Collar Back
Deck Wash
Nozzle
The cutting blades must be kept sharp at all times.
Sharpen the cutting edges of the blades evenly so
that the blades remain balanced and the same angle
of sharpness is maintained.
If the cutting edge of a blade has already been sharp-
ened many times, or if any metal separation is present,
it is recommended that new blades be installed. New
blades are available at your authorized dealer.
The blades may be removed as follows.
•
Remove the deck from beneath the tractor, (refer
to Deck Removal on page 28) then gently flip the
deck over to expose its underside.
•
Use a 15/16 inch wrench to hold the hex nut on
top of the spindle assembly when loosening the
hex nut securing the blade. A block of wood may
be placed between the deck housing and the cut-
ting edge of the blade to help in breaking loose
the hex nut securing the blade. See Figure 35.
HEX FLANGE NUT
SPINDLE ASSEMBLY
•
When reinstalling the blades, be sure they are
installed so that the wind wings are pointing
upward toward the top of the deck.
•
Reinstall the deck (refer to Deck Installation on
page 29).
31
Figure 35
WOOD
BLOCK
Hide quick links:
Advertisement
Table of Contents
