Setup; Installing The Handle; Installing The Fuel Tank - Toro 22192 Operator's Manual

Setup

Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
Note: Determine the left and right sides of the machine
from the normal operating position.
1

Installing the Handle

Parts needed for this procedure:
1 Handle
2 Bolt (5/16 x 7/8 inch)
2 Bolt (5/16 x 1-1/2 inches)
4 Washer
4 Locknut (5/16 inch)
3 Cable tie
Procedure
1. Mount the handle to the mower housing with 2 bolts
(5/16 x 7/8 inch), 2 bolts(5/16 x 1-1/2 inches), 4
washers, and 4 locknuts (Figure 3).
Description
Handle
Bolt (5/16 x 7/8 inch)
Bolt (5/16 x 1-1/2 inches)
Washer
Locknut (5/16 inch)
Cable tie
Fuel tank
Adapter bracket
Bolt (1/4 x 3/4 inch)
Locknut (1/4 inch)
No parts required
Qty.
1
2
2
Install the handle.
4
4
3
1
1
Install the fuel tank.
2
2
–
Fill the crankcase with oil.
1. Housing
2. Handle
Note: Install the washers with the cup side facing
the handle.
Note: You can adjust the handle height for more
comfortable operation. Securing the lower handle
end in the upper hole lowers the handle; securing the
lower handle end in the lower hole raises the handle.
2. Use the cable ties provided to secure the control
cables to the handle.
6
Use
Figure 3
3. Bolt (5/16 x 1-1/2 inches),
washer, and locknut
4. Bolt (5/16 x 7/8 inch),
washer, and locknut