Ii Operation - Cub Cadet 2164 Operator's Manual

WARNING
RECEIVE INSTRUCTION
operator's manual. Learn to operate this
machine SAFELY. Don't risk INJURY or
DEATH.
1. Before starting the engine or beginning op-
eration, be familiar with the controls. The
operator must be seated, the PTO switch in
the "OFF" position and the brake pedal fully
depressed.
2. Keep all shields in place. Keep away from
moving parts.
3. NO RIDERS! Keep all people and pets a
safe distance away. Look behind to both
sides before backing up.
4. DO NOT direct the mower discharge at
people.
5. Avoid slopes. Tractors can be rolled over.
6. Before leaving the operator's seat: Shut
off the PTO, engage the brake pedal lock,
shut off the engine and remove the ignition
key. Wait for all movement to stop before
servicing or cleaning.
7. Do not fill the fuel tank when the engine is
running or while the engine is hot. Tighten
the fuel cap securely.
BEFORE OPERATING YOUR TRACTOR
1. Before you operate the tractor, study this manual
carefully. It has been prepared to help you operate
and maintain your tractor with utmost efficiency.
2. Familiarize yourself with the operations of all the
instruments and controls.
3. This engine is certified to operate on unleaded
gasoline. Fill the fuel tank with only clean, fresh,
unleaded gasoline with a minimum of 85 octane.
Do not mix oil with gasoline. Purchase fuel in a
quantity that can be used within 30 days to assure
fuel freshness.
In countries other than the U.S.A., leaded gasoline
may be used if it is commercially available and un-
leaded is not available.
SECTION II. OPERATION
- Read the
14
NOTE
Some fuels, called oxygenated or reformulated
gasolines, are gasoline blended with alcohols
or ethers. Excessive amounts of these blends
can damage the fuel system or cause
performance problems. Do not use gasoline
which contains Methanol. If any undesirable
operating symptoms occur, use gasoline with a
lower percentage of alcohol or ether.
4. Check the engine and transmission oil levels.
5. Clean the air cleaner element if necessary.
6. Check the tire inflation pressures.
7. Adjust the seat for operator's maximum comfort,
visibility and for maintaining complete control of
the tractor.
8. Remove the side panels and clean any
accumulated grass and debris from the engine air
inlet screen. Also clean the dash air intake
screen, grille and side panels to ensure adequate
cooling.
9. Refer to the various sections of the Operator's
Manual for additional information.
STARTING THE ENGINE
WARNING
For personal safety, the operator must be sitting
in the tractor seat when starting the engine.
WARNING
This unit is equipped with a safety inerlock
system designed for the protection of the
operator. Do not operate the tractor if any part
of the interlock system is malfunctioning.
Periodically check the functions of the interlock
system for proper operation as described
below:
• The safety interlock system prevents the en-
gine from cranking or starting unless the
brake pedal is fully depressed and the PTO
clutch engagement switch is in the "OFF" po-
sition.