Lubrication Table - Cub Cadet 2164 Operator's Manual

Check
at
Point of
Hours
Lubrication
Engine crankcase Check
before
each
use
Hydro drive unit Check
and transmission
before
case with filter
each
use
Steering knuckles 10
and front axle
pivot bolt
Front wheel 30
bearings
Steering gear 30
housing
10
Deck spindles
Spindle belt 10
idler arm
Deck front gauge 50
wheels
Foot and lift con- 10
trol pivot points

LUBRICATION TABLE

Change
at Capacity
Hours
50 Approx.
3 pints
8 ounces
Add as Approx. Cub Cadet Drive System Fluid Plus
needed 6 qts NOTE: Cub Cadet Drive System Fluid Plus is specially
formulated for this application. If any other oil is used
Cub Cadet will not be responsible for substandard
performance. Failures due to use of improper fluid
are not covered by warranty. For maximum protec-
tion, use Cub Cadet Drive System Fluid.Plus
Use 251H EP grease or equivalent No. 2 multe-
purpose lithium grease and apply two strokes
(minimum) or sufficient grease to flush out old
grease and dirt.
Two strokes (minimum) of the lubricator using 251H
EP grease or equivalent No. 2 multi-purpose lithium
grease.
Two strokes (minimum) of the lubricator using 251H
EP grease or equivalent No. 2 multi-purpose lithium
grease.
Two strokes (minimum) of the lubricator using 251H
EP grease or equivalent No. 2 multi-purpose lithium
grease.
Two strokes (minimum) of the lubricator using 251H
EP grease or equivalent No. 2 multi-purpose lithium
grease.
Use 251H EP grease or equivalent No. 2 multi-purpose
lithum grease.
Use a liberal amount of high grade lubricating oil.
Anticipated Air Temperature
Above +40°F 0° to 40°F
Cub Cadet Cub Cadet
Engine Oil Engine Oil
SAE 30 SAE5W30
or 10W30
52
Below 0°F
Synthetic
Engine Oil SAE
5W20 or 5W30