Canon LBP6780x Manual page 572

[Proxy Settings]
[Proxy
Authentication]
[Off], [On]
[User Name]
[Password]
[SNTP] [Off], [On]
[Discovery
[Off], [On]
Response]
[IPSec] [Off], [On]
[NetWare]: [Off], [On]
[Frame Type]
Detect], [Ethernet
II], [Ethernet 802.2],
[Ethernet 802.3],
[NetWare Settings]
[Ethernet SNAP]
[Print Service]
[Bindery PServer],
[RPrinter], [NDS
PServer], [NPrinter]
[AppleTalk] [Off], [On]
[SMB Server]: [Off],
[On]
*
[SMB]
[SMB Print]
[On]
[SNMP Settings]
[SNMP v. 1 Settings]
[SNMP v. 1] [Off], [On]
[Dctd. Community]:
[Dctd.
[Off], [Read/Write],
Community Set.]
[Read Only]
[SNMP v. 3]: [Off],
[On]
[User Settings 1] to
[SNMP v. 3
[User Settings 5]
Settings]
*
If you want to use the proxy authentication function, specify [On].
:
Enter the user name to be used for the proxy authentication. Up to
*
: -
24 alphanumeric characters can be entered.
Enter the password to be used for the proxy authentication. Up to 24
*
: -
alphanumeric characters can be entered.
When obtaining time using the SNTP Client function, specify [On].
If you want to set the printer so that it responds to searches that used
the multicast discovery function, specify [On].
When using the IPSec function, set it to [On].
*
: [Auto
Configures the NetWare network settings.
*
:
Specifies whether the printer should use AppleTalk.
Specifies whether the printer should use
SMB.
*
: [Off],
Specify the settings related to SNMP protocol.
Specify the settings related to SNMP v. 1 protocol.
Specify whether to use the SNMP v. 1 protocol.
[Dctd. Community] specifies whether to permit accessing to the
Management Information Base (MIB) that SNMP manages using the
name of dedicated community for Canon equipment.
*
:
Specify the settings related to SNMP v. 3 protocol.
[Auth. Password]
*
Specify the settings for [NTP Server Name] and [Polling
Interval] from the Remote UI.
"Configuring the Protocol Settings"
*
Specify the setting for [Scope Name] from the Remote UI.
"Configuring the Protocol Settings"
"Setting the IPSec Encryption Communication Function "
"Configuring the Protocol Settings"
"Configuring the Protocol Settings"
"Network Settings for the Printer (SMB) "
"Restricting the Users Who Can Monitor/Change the Settings
Using the SNMP Protocol"
To use Canon utility software, it may be necessary to select
[Read/Write].