Toshiba W808 Service Manual page 46

Buttons to control a remote-
controllable DSS
®
Once you complete the set-up for a remote
controllable DSS ® satellite receiver, your DSS
satellite receiver can be controlled by the
following buttons on the remote control of the
VCR.
• POWER (CABLE BOX)
®
To turn the DSS satellite receiver on or off.
• CH UP/ CH DOWN (CABLE BOX)
To select satellite channels in the upper or
lower direction. (not applicable to some brands
of DSS ® satellite receiver.)
• Number buttons (0 – 9)
To select desired channels to record.
OFF: if your DSS
remote-controllable.
• Satellite channels will be selected by the own
channel selector of the DSS
The VCR channel should be set to the output
channel of the DSS
→ Go to step 8.
7
Select "BRAND TYPE" using STOP , and enter a brand code
of your DSS
to the table on the next page.
Example: For a TOSHIBA DSS
number 99.
USE
OUT UT CH
CO
BRA
n
E D:
Make sure that the background of the above display has changed to
the satellite program on channel 200. If not, relocate the DSS
satellite receiver on the VCR so that it can receive the infrared signal.
8
Press PROG. to exit.
Notes
• If your satellite channel does not change to 200 in step 7, the DSS
receiver will not be able to change channels in the timer recording. In this
case, set "CONTROL" to "OFF" in step 6.
• The VCR Plus+ C
• The DSS ® satellite receiver control is not compatible with the cable box
control.
satellite receiver
®
® satellite receiver is NON
®
satellite receiver.
®
satellite receiver.
® satellite receiver using number buttons . Refer
® satellite receiver, identified by
PROGRAM SET UP PRESET
n
O C . BOX D S S
P 3 C H
n n
T O R L O FF O
n
n
O . 9 9
D T YPE
PROG
3 ®
system recording is not available on satellite channels.
Table of DSS
codes
Brand name of your
DSS ® satellite receiver
TOSHIBA
RCA
SONY
PROGRAM SET UP
n
O
USE
OUT UT CH P
n
CO T O R L O FF
n
E D:
PROG
VCR display
® satellite receiver brand
Brand code
99
98
97
PRESET
C . BOX D S S
3 C H
n
O
®
® satetllite
43