Omega Engineering CN3271 Series User Manual page 29

Loading Default Configuration Parameters Loading Default Configuration Parameters Loading Default Configuration Parameters Loading Default Configuration Parameters Loading Default Configuration Parameters
The configuration parameters can be loaded with
predetermined default values. These are the
settings loaded into the instrument prior to
shipment from the factory. To load the default
values proceed as follows:
a ) Internal switch V101 must be open.
b) The upper display will show:
c) Press the key; the lower display will show
the firmware version.
d) Still holding the key, press the key; the
display will show:
e ) Press the key to select Table 1 (Euro-
pean) or Table 2 (American) default
parameters; the display will show:
LHL-A-NEUTRO.pmd 2
f) Press the FUNC key; the display will show:
This indicates that the loading procedure has
been initiated. After about 3 seconds the
procedure is complete and the instrument reverts
to the "COnF" display. The following is a list of the
default configuration parameters loaded during
the procedure:
Appendix A.2
19/04/2004, 15.28