Pan / Tilt / Zoom Control And Connections - Sylvania SY17TD8144-A Instruction Manual

Pan / Tilt / Zoom Control and Connections

The DVR supports the control of a single Pan/Tilt/Zoom camera on Channel 1.
Currently only PTZ camera's using the 'Pelco D' protocol may be used.
1) Connect a compatible PTZ camera to Channel 1
2) Connect the RS-485 control wires to the RS-485 terminals on the back of the
monitor.
3) Go to the SYSTEM submenu and set the PAN/TILT(CH1) option to "Y";
4) Enter Pan/Tilt Zoom mode by holding the PAN/TILT key on the monitor for 3
seconds, or press the Pan/Tilt button on the remote control
5) You will see a contracted screen with a blue border. Use the Arrow keys to move
sideways, and ENTER to select whether to MOVE, ZOOM, or FOCUS the
camera.
6) If you have selected MOVE, you can use all four-arrow keys to Pan and Tilt in all
directions. If you selected ZOOM or FOCUS, use the arrow keys to Zoom /
Focus IN and OUT.
7) Select and press ENTER on the EXIT option to escape the Pan/Tilt mode.
Note: the system automatically exits Pan/Tilt mode after 20 seconds of inactivity.
Refer to the diagram below for an illustration of Pan/Tilt Zoom mode.