22
TROUBLESHOOTING
Faults
Combination instrument shows nothing
on the display
Engine does not crank when the elec-
tric starter button is pressed
Engine turns only if the clutch lever is
drawn
Engine turns although a gear is
engaged
Engine turns but does not start
Possible cause
Fuse 1 blown
Main fuse burned out
The battery is discharged
Ignition/steering lock is faulty
Emergency OFF switch is off
Operating error
The battery is discharged
Safety start system is faulty
ICU is not enabled
CAN bus communication error
Fault in EFI control unit.
Fault in MCU control unit.
The vehicle is in gear
Safety start system is faulty
Safety start system is faulty
The plug-in connection of the fuel hose
connection is not connected
Action
–
Change the fuses in the fuse box. (
–
Change the main fuse. (
–
Recharge the battery.
–
Check the quiescent current.
–
Check the ignition/steering lock.
–
Press the emergency OFF switch to the posi-
tion ON
.
–
Carry out the start procedure. (
–
Recharge the battery.
–
Check the quiescent current.
–
Read out the fault memory using the KTM diag-
nostics tool.
–
Activate the ICU.
–
Read out the fault memory using the KTM diag-
nostics tool.
–
Read out the fault memory using the KTM diag-
nostics tool.
–
Read out the fault memory using the KTM diag-
nostics tool.
–
Shift the transmission to idle
–
Read out the fault memory using the KTM diag-
nostics tool.
–
Read out the fault memory using the KTM diag-
nostics tool.
–
Connect the plug-in connection of the fuel line.
201
p. 165)
p. 163)
(
p. 159)
p. 80)
(
p. 159)
.