KTM 690 Duke USA Owner's Manual page 58

8 RIDING INSTRUCTIONS
Note
Engine failure Overheating of engine.
–
If the coolant temperature warning lamp lights up, stop and switch off the engine. Allow the engine to cool down and check the
coolant level in the radiator, and top up if necessary. If you continue with the coolant temperature warning lamp alight, you may have
engine failure.
Info
If unusual noises arise during operation, stop immediately, park the vehicle properly, and contact an authorized KTM workshop.
–
When conditions allow (incline, road situation, etc.), you can shift into a higher gear.
–
Release the throttle while simultaneously pulling the clutch lever, shift into the next
gear, release the clutch, and open the throttle.
Info
You can see the positions of the 6 forward gears in the figure. The neutral or idle
position is between the first and second gears. First gear is used for starting off
or for steep inclines.
The operating temperature is reached when 5 bars of the temperature indicator
light up.
602555-10
–
After reaching maximum speed by fully opening the throttle grip, turn the throttle back
so it is ¾ open. This will barely reduce the speed but fuel consumption will be consid-
erably lower.
–
Accelerate only up to a speed suitable for the road surface and weather conditions. Par-
ticularly in bends, do not shift, and accelerate very carefully.
–
To shift down, brake if necessary and close the throttle at the same time.
–
Pull the clutch lever and shift into a lower gear, release the clutch lever slowly, and
open the throttle or shift again.
56