KTM 2015 450 SX-F EU Owner's Manual page 82

17 SERVICE WORK ON THE ENGINE
–
Position oil screen
–
Position the pin wrench through the drilled hole of the screw plug in the opposite
section of the engine case.
–
Push the oil screen all the way into the engine case.
102074-10
–
Mount and tighten screw plug
Guideline
Screw plug, oil screen
–
Mount and tighten the oil drain plug
Guideline
Oil drain plug with magnet
102075-10
–
Remove screws
102076-10
–
Pull oil filter
Circlip pliers reverse (51012011000)
–
Completely drain the engine oil.
–
Thoroughly clean the parts and sealing area.
102077-10
– Lay the motorcycle on its side and fill the oil filter housing to about ⅓ full with
engine oil.
–
Insert the oil filter into the oil filter housing.
–
Lubricate the O-ring of the oil filter cover and mount it with the oil filter cover
–
Mount and tighten the screws.
Guideline
Screw, oil filter cover
–
Stand the motorcycle upright.
102078-10
–
Remove the oil filler plug
engine oil.
Engine oil
Info
Too little engine oil or poor-quality engine oil results in premature wear to
the engine.
–
Install and tighten the oil filler plug with O-ring.
601828-10

with the O-rings on a pin wrench.

with the O-ring.


. Remove the oil filter cover with the O-ring.

out of the oil filter housing.

with the O-ring from the clutch cover and fill up with
1.50 l (1.59 qt.)
M20x1.5 15 Nm
(11.1 lbf ft)
with the magnet and a new seal ring.
M12x1.5 20 Nm
(14.8 lbf ft)
M5 6 Nm (4.4 lbf ft)
Engine oil (SAE 10W/50) (
80

.
p. 95)