Standby Mode - Texas Instruments 600 Series User Manual

Standby Mode

In Standby mode, data remains in memory while
the computer powers down unused devices to
save power. The standby indicator lights up in
Standby mode.
Press the Standby hot key (Fn+F4) to enter
Standby mode. The computer also enters
Standby mode if the
in Setup is enabled and times out.
To resume from Standby mode, press any key or
touch the touchpad. When enabled in setup, the
computer also resumes from Standby mode if an
incoming ring is detected by an attached
modem.
Note: The computer acts on the key you press.
To prevent accidental entry of a key, press a non-
printing character such as Shift, Ctrl or Alt.
Power Saving Modes
STANDBY TIMEOUT
parameter
1-9