JVC RX-F10S Service Manual page 15

Home theater receiver

Hide thumbs Also See for RX-F10S:

Enlarged version

3.17 Removing the fan motor

(See Figs.22 and 23)

• Remove the top cover.

(1) From the top side of the main board, remove the tie bands

bundling the wires. (See Fig.22.)

Reference:

After reassembling, bundle the wires with the new tie

bands as before. (See Fig.22.)

(2) Disconnect the wire from the connector

ondary board. (See Fig.22.)

(3) Remove the two screws W attaching the fan bracket. (See

Fig.22.)

(4) Take out the fan motor with the fan bracket.

(5) Remove the tie band bundling the wire. (See Fig.23.)

Reference:

After reassembling, bundles the wire with the new tie

band as before. (See Fig.23.)

(6) Remove the screw X and screw X' attaching the fan motor

to the fan bracket. (See Fig.23.)

Reference:

When attaching the screw X', attach the fan cover with it.

(See Fig.23.)

CN207

on the sec-

Fan bracket

Tie bands

Fan motor

Wires

Secondary board

Fig.22

Fan motor

Fan cover

Fig.23

CN207

Wire

Wire clamp

(No.MB264)1-15

Table of Contents