Installation - Samsung NV70*55 Series User Manual

installation

Safety instructions for the installation
This oven may be installed only by an approved electrician. The installer is responsible for
connecting the appliance to the main supply, while observing the relevant safety regulations.
• Ensure protection from live parts when installing the oven.
Power connection
If the appliance is not connected to the mains with a plug, a multi-pole
isolator switch (with at least 3 mm contact spacing) must be provided in
order to satisfy safety regulations. The power cable (H05 RR-F or H05
VV-F, min., 2.5 mm²) must be of sufficient length to be connected to the
oven, even if the oven stands on the floor in front of its built-in cabinet.
Open the rear connection cover of the oven with a screwdriver and loosen
the screws of the cable clamp before you connect the power lines to the
relevant connection terminals. The oven is earthed via the (
The yellow and green cable (earth connection) must be connected first and be
longer than the others. If the oven is connected to the mains with a plug, this plug must remain accessible
after the oven is installed. Samsung will take no responsibility for accidents that originate from a missing or
faulty earth connection.
WARNING: Do not allow the connecting cable to become trapped during installation, and
prevent it coming into contact with hot parts of the oven.
Installation in the cabinet
With built-in furniture, plastic surfaces and adhesive for the oven should be resistant to 90 °C inside of
the furniture and to 75 °C for adjacent furniture. Samsung will take no responsibility for damage of plastic
surfaces or adhesive from the heat.
1
545
560
595
595
21
3
min.
min. 560
550
min. 50
Lower element
Push the appliance completely into the cabinet and fix the oven firmly on both sides using 2 screws. Make
sure that a gap of at least 5 mm should be left between the appliance and the adjacent cabinet.
After installation, remove the vinyl protective film, tape, paper and accessories from the door and inside
of oven. Before uninstalling the oven from the furniture, disconnect the oven from the power supply and
release the 2 screws on the both sides of the oven.
WARNING: The built-in furniture must have a minimum ventilation gap for Air-flow as shown
on picture. Do not cover this hole with strips of wood, for this is used to provide ventilation.
The front exterior of the oven such as handle is different model by model. But the size of the
oven in the picture is same.
Prezio Airv_NV70H5587CB_EU_DG68-00542A-00_EN.indd 10
2
Lower
element
572
Airflow through the ventilation gap
4
50
min. 590
-max. 600
min. 600
min. 560
Top element
English - 10
BROWN
or BLACK
)-terminal.
There should be a ventilation gap
Top
in the base of the kitchen cabinet
element
where the oven is to be placed. For
ventilation, a gap of about 50 mm
should be left between the lower shelf
and the supporting wall. If the oven is
to be installed below a hob, the hob's
installation instructions should be
followed.
5
min. 550
BLUE or YELLOW
WHITE and GREEN
2014-04-23 9:40:44