Other Functions; Demo Mode; View Mode; All Clear - Furuno NX-300-D Operator's Manual

4.1 DEMO Mode

The DEMO mode provides simulated operation of this unit. Connection of antenna is not
necessary. You may select stations and messages manually or automatically and demo
messages are received. All controls are operative.
Note: Turning on the DEMO mode erases all messages.
Press the [PWR] key while pressing
momentarily. "DEMO" appears at the top of the screen when the DEMO mode is active.
To escape the DEMO mode, press the [PWR] key while pressing
appears momentarily.

4.2 VIEW Mode

The NX-300 ordinarily displays messages in their entirety. The VIEW mode, however displays
messages character by character.
Press the [PWR] key while pressing
momentarily. "VIEW" is displayed at the upper left corner of the display.
To quit the VIEW mode,: repeat above procedure. "RESET VIEW MODE!" appears.

4.3 All Clear

This function deletes all messages and restores default settings. When the NX-300 is first
installed, you should clear all data.
Press the [PWR] key while pressing
momentarily while data is being cleared. Then, all default settings are restored.

4. OTHER FUNCTIONS

to turn the power on. "SET DEMO MODE!" appears
DEMO mark
Figure 4-1 Message display
to turn the power on. "SET VIEW MODE!" appears
to turn the power on. "RESET BACKUP DATA!" appears
. "RESET DEMO MODE!"
4-1