Preparing Hot Water; Heating Liquids With Steam; Preparing Milk Froth - Siemens TK 50 N 01 Operating Instructions Manual

Permanently changing
the amount of liquid
The preset amount for a small or large cup can
be changed.
S
Press button
required amount of coffee has run through.
The amount can be changed again at any
i
time.

Preparing hot water

Hot water can be prepared with this function,
e.g. for a cup of tea.
d
Risk of burns
The nozzle becomes very hot, take hold of the
nozzle by the plastic part only.
S
Screw the nozzle 15 onto the adapter 13
of the steam pipe 12 (Fig. 3).
S
Hold a glass or a cup under the nozzle 15.
S
Push the lever 4 forwards.
Hot water runs out of the nozzle 15.
S
To stop the hot water, pull back the lever 4.

Heating liquids with steam

d
Risk of scalding
Steam is very hot. It may cause the liquid
to splash.
S
Screw the nozzle 15 onto the adapter 13
of the steam pipe 12 (Fig. 3).
S
Press button
The appliance now heats up, button
flashes. When button
light up, steam can be drawn.
S
Immerse the nozzle 15 deep into the liquid,
but do not touch the bottom of the vessel.
S
Push the lever 4 forwards (Fig. 4).
S
Slowly rotate the vessel.
The liquid is heated.
S
When the liquid is hot, pull back the lever 4.
The appliance steams briefly.
Downloaded from CoffeeMachineManual.com Manuals
7 or button 8 until the
2.
1 and button
Warning: The appliance now remains in steam
mode for approx. 1 minute.
Approx. 1 min. after steam has been drawn,
the appliance cools down by intermittently
drawing off steam into the drip tray 16.
Coffee can now be brewed again.
The cooling down process can be
i
accelerated by pressing button
As soon as the appliance has cooled
down, clean the nozzle 15.
Dried residue is difficult to remove.
See the chapter on Care and daily cleaning".

Preparing milk froth

Frothing or heating milk
d
Risk of scalding
The steam is very hot.
Touch the frothing device by the plastic part
only.
S
Firmly fit together the frothing device for
CAPPUCCINO/CAFFELATTE 14 (Fig. 5/a).
There must be no gaps.
S
Connect the frothing device 14 firmly to the
adapter 13 on the steam pipe 12 (Fig. 5/b).
S
Immerse the hose into a vessel containing
milk.
S
Move the selector on the frothing device 14
to CAPPUCCINO (milk froth) or CAFFELATTE
(hot milk).
S
Place a cup or a glass under the nozzle of the
frothing device 14.
1
S
Press button
2
The appliance now heats up, button
flashes. When buttons
steam can be drawn.
S
Push the lever 4 forwards (Fig. 4).
The milk is drawn in, heated and frothed.
S
To end the process, pull back the lever 4.
The appliance steams briefly.
2.
2.
1 and 2 light up,
en
1
13