Denon DBT-1713UD Owner's Manual page 12

n Checking the network connection
After connection, test the Internet connection with "Connection Test"
on the SETUP menu.
• If "Network is FAILED." is displayed in the test, check the IP address with "Network" in "Information"
on the SETUP menu, then set "DHCP" to "Manual" (vpage 38).
• The unit can use the DHCP function to automatically set up the network.
• When setting up your network manually, after subscribing to an ISP, make the settings according to
directions in "Network" on the SETUP menu (vpage 38).
• If you connect the unit to a network without a DHCP function, conduct IP address and other settings
according to "Network" on the SETUP menu (vpage 38).
• The unit does not support PPPoE. If you subscribe to a service that is set with PPPoE, a PPPoE
compatible router is required.
• When setting up the network manually, consult with your network administrator for the settings to
make.
n Registering the connected device for the network
For playing files stored on a device connected via a network, the device must have the unit registered
in advance.
• For registering, refer to the operation manual supplied with the server.
For Internet connections, use an ISP (Internet Service Provider). Ask your local dealer for details.
NOTE
• Do not connect an NETWORK connector directly to the LAN port/Ethernet connector on your
computer.
• It is necessary to subscribe to an ISP in order to connect to the Internet. If you already have a
broadband connection, there is no need to subscribe anew.
• The router you can use varies with the ISP. For more information, contact your ISP or PC dealer.
• DENON assumes no responsibility whatsoever for any communication errors or problems resulting
from customer's network environment or connected devices.
Downloaded From DvDPlayer-Manual.com Denon Manuals
(vpage
DVD
Checking the network connection
38) in "Network"
After you connect this unit to the router with a LAN cable, use the following procedures to check the
network connection.
1
POWER X
Press
• Switch the input source for the TV and AV receiver so that the video output
from this unit is displayed on the TV screen.
2
Press SETUP .
3
uio p
Use
"Connection Test"
The connection test starts.
• If the connection is not established, a message is displayed. Check the
connection settings and connection environment.
9
Connecting to a home network (LAN)
to turn on power to the unit.
to select "General Settings" – "Network" –
(vpage 38).