Chevrolet ranger rt Owner's Manual page 92

HOWTO: Waste Water Dumping
Pin you need to remove to raise the flap
and lower the hose pipe
• • Locate the R-shaped pin (spring type cotter pin) that retains the aluminum flap on the end of the waste water pipe. You can
see this pin through the hole below the gray and back handles.
• • Pull this pin loose - it won't get lost because it's on a retaining tether. Once the pin is out, swing the bottom of the flap
toward you. The waste water pipe will drop a couple of inches as the flap clears the small rod attached to the pipe.
• • Once the pipe is low enough to clear the bodywork, pull the end out slightly and undo the small black plastic cap on the
end of the waste water hose. This lets air into the hose so you can extend it further. If you do not feel resistance as you pull
the hose out, you probably left one of your waste water valves open, and should not remove either the small cap or the big
hose end until you are as near the drain as possible. Check to make sure both the gray and black handles are pushed all
the way in, and only loosen the small cap a small amount to allow air to bleed into the wastewater hose enough to extend
it to the drain.
Waste water hose pipe in lowered
position
© 2014 by Roadtrek, Inc.
89