Chevrolet ranger rt Owner's Manual page 113

HOWTO: De-Winterizing
Water heater fittings
• • Re-install the water heater if you stored it outside the vehicle. Leave it unplugged and off. Check to be sure the two fittings
at the top of the water heater are hand tight. Tighten slightly at this stage and recheck after you undo the bypass valves,
repressurizing the water heater.
• • Return the three valves under the side bench down by the water pump to their summer positions - vertical for all three
valves. The handles should be turned 90 degrees from their winterized positions so that they parallel the two vertical lines,
and the third valve on the bottom horizontal line is across the line.
Fresh tank drain
© 2014 by Roadtrek, Inc.
110