JUKI SC-910N Engineer's Manual page 25

Operating procedure
[Maintenance personnel level]
Press communication mode switch
Refer to [Information screen (Maintenance personnel level)
Pictograph on the left end of the communication screen is shown in reverse video.
Communication screen (Maintenance personnel level)
Data communication
source
7. Communication setting
1 Data selection
Press data selection switch
Data selection screen
Select the data to perform communication, and press set key switch
2 Communication method selection
Press communication method selection switch
Communication method selection screen
for approximately three seconds in the information screen.
Kind of selected data
Data
communication
destination
in the communication screen.
– 21 –
Data selection
Communication
method selection
in the communication screen.
Start of
communication
.