To Connect To A Tv With The Component Video Input Jacks - JVC XV-SA70BK Instructions Manual

To connect to a TV with the component video input jacks

You can enjoy high picture quality by connecting the unit's COMPONENT VIDEO OUT jacks to the COMPONENT VIDEO IN
jacks of your TV with the video cables.
The unit
SUBWOOFER
PCM / STREAM
OPTICAL COAXIAL
DIGITAL OUT
• Set the NTSC - PAL selector on the rear panel to match the system of your TV.
The unit can playback a disc recorded with either the NTSC or PAL format and output a video signal with the format
set by the NTSC - PAL selector.
However, if you connect the unit to a NTSC/PAL compatible TV, by setting "MONITOR TYPE" in "PREFERENCE 1" to
an appropriate "MULTI" option, the unit outputs a video signal by the same format recorded on the disc (i.e. if you
play an NTSC disc, the unit output a signal by the NTSC format) regardless of the NTSC - PAL selector.
• The unit supports the progressive scan system for the NTSC video, as well as the conventional interlace scan system.
If your television or monitor supports the progressive video input, you can enjoy a high quality picture by making
the Progressive scan mode active.
Set the scan mode correctly when you connect the unit to an NTSC or NTSC/PAL compatible TV (see next column).
How to make the Progressive scan mode active (for NTSC disc only)
¶ While the NTSC - PAL selector on the rear panel is set to "NTSC"
Press and hold VFP - PROGRESSIVE SCAN button for a few seconds.
The scan mode switches between the progressive scan and interlace scan modes. When the progressive scan mode is
selected, the PROGRESSIVE indicator on the front panel is lit in red. This indicator turns green during playback of a film-
source DVD VIDEO disc while the "PROGRESSIVE MODE" on the "PREFERENCE1" display is set to AUTO, FILM or
SMART (see page 56).
OPEN
/CLOSE
REPEAT
TV1
1
TV4
4
TV7
7
TV -/--
10
ANGLE
DIGEST
• You should note that not all Progressive TV and High-Definition TV sets are fully compatible with the unit and may
cause artifacts to be displayed in the picture. In case of progressive scan picture problems, it is recommended that you
switch the setting to the "Interlace Scan" output.
Downloaded From DvDPlayer-Manual.com JVC Manuals
Blue
Green Red
CENTER RIGHT LEFT
REAR
VIDEO
COMPONENT
RIGHT LEFT
Y P P
B R
FRONT
S-VIDEO
AUDIO OUT VIDEO OUT
Red White
Audio cable
(supplied)
TV DVD
STANDBY/ON
TV DVD
3D TV/VIDEO
PHONIC CANCEL
RETURN
TV2 TV3
2 3
TV5 TV6
5 6
TV8 TV9
8 9
TV0 MUTING
+10
0
SUBTITLE AUDIO VFP
VFP -
S.FREQ PROGRESSIVE
SCAN
+
PAGE - ZOOM
PROGRESSIVE
SCAN
SELECT
Component video cable
(not supplied)
AV COMPU LINK
VIDEO OUT
SELECT
NTSC PAL
STANDBY/ON
STANDBY/ON
DVD AUDIO PROGRESSIVE
PROGRESSIVE indicator
Green
T V
IN
Y
S-VIDEO
VIDEO
White
LEFT
AUDIO
RIGHT
Red
XV-SA70 DVD AUDIO/DVD VIDEO/SUPER VCD/VCD /CD PLAYER
OPEN/CLOSE
0
4 ¢
STOP PLAY
SKIP
7 3
Getting started
Blue
Red
P B P R
IN
PAUSE
8
DVD/SUPER VCD/VCD/CD
17