Mounting The Camera On A Tripod - Panasonic AJ-SPX900E Operating Instructions Manual

<Notes>
A USB driver must be installed on the PC.
AJ-SPX900Eis only applicable to USB 2.0, not to USB
1.1.
Only one AJ-SPX900Eat a time must be connected to the
PC via USB.
The P2 card must not be removed when it is connected
via USB.
While a USB connection is established, the P2 card's
access LED should not be lit except when access is
being carried out.
While the USB is turned ON, operations such as
recording, playback and thumbnails will not be available.
During a USB connection, "DRIVE" is lit in the status
indication area of a display window.
Also, "USB DRIVE" is displayed in the system information/
warning area in the viewfinder.
When the connection is not correctly established, both of
these indications blink.
MEDIA
E
BATT
E
DRIVE
8 6 % ' 5 , 9 (
 )         

 % $   E% )         
3
There are two ways to terminate the USB mode, as follows:
Turn the POWER switch of the AJ-SPX900E OFF.
Set the USB to OFF from the menu (operations).
Downloaded From CamcorderManual.com Panasonic Manuals
F
30
F
40
OO
13 24
-dB
w
)   = 
w

5-6 Mounting the Camera on a Tripod

When mounting the camera on a tripod, use the optional tripod
adapter.
1
Mount the tripod adapter on the tripod.
Tripod Adapter
<Note>
Select an appropriate hole in the adapter, taking into
account the center of gravity of the camera and tripod
adapter combined.
Also, make sure that the diameter of the selected hole
matches the diameter of the pan head screw.
2
Mount the camera on the tripod adapter.
Slide the camera forward along the grooves until you hear a
"click".
Removing the Camera from the Tripod Adapter
Tripod Adapter
Red Lever
While holding the red lever down, move the black lever in the
direction of the arrow, and slide the camera backward to remove
it.
<Note>
If the tripod adapter pin does not return to its original position
after the camera has been removed, hold the red lever down and
move the black lever in the direction of the arrow again, in order
to return the pin to its original position.
Please note that the camera cannot be mounted if the pin
remains in the center.
Pan head
Black Lever
77
5