Back Color; Fan Control; Lamp Power - Panasonic PT-LB10NTU Operating Instructions Manual

Noise Reduction (NR)
(S-VIDEO/VIDEO only)
If noise occurs from the projector
because of a poor input signal, set
"NR" to "ON".
To turn off the "NR" feature, set it to
"OFF".
BLACKBOARD
(PT-LB10NTU/PT-LB10U/PT-
LB10SU only)
Set to "ON" when "PICTURE
MODE" is set to "BLACK-BD".
(Refer to page 37.)

BACK COLOR

B A C K C O L O R
This sets the color which is
projected onto the screen when no
signal is being input to the projector.
FRONT/REAR
F R O N T / R E A R
This setting should be changed in
accordance with the projector
setting-up method.
(Refer to page 19.)
FRONT
When the projector is placed in front
of a screen.
REAR
When using a translucent screen.
Downloaded From projector-manual.com Panasonic Manuals
B L U E
[
B L A C K
F R O N T
[
R E A R
DESK/CEILING
D E S K / C E I L I N G
C E I L I N G
This setting should be changed in
accordance with the projector
setting-up method.
(Refer to page 19.)
DESK
When the projector is placed on a
desk or similar.
CEILING
When the projector is suspended
from a ceiling using the ceiling
bracket (sold separately).

FAN CONTROL

F A N C O N T R O L S T A N D A R D
Set "FAN CONTROL" to "HIGH",
when using this projector at high
elevations (above 1 400 m) only.

LAMP POWER

L A M P P O W E R
This setting changes the lamp
brightness. When set to "LOW", the
luminance of the lamp is reduced,
but the projector uses less power,
and the operating noise is also
reduced. This can help to extend
the lamp's operating life. If using the
projector in small rooms where high
luminance is not required, it is
recommended that you set the
"LAMP POWER" to "LOW".
NOTE:
B "LAMP POWER" cannot be set
when no signal is being input.
D E S K
[
[
H I G H
H I G H
[
L O W
E -45
NGLISH