Table of Contents
Advertisement
Note
f If [OFF] is set, the warning message will not be displayed on the projected image even when warning condition such as [TEMPERATURE
WARNING] is detected while using the projector. Also, the following countdown message is not displayed: the message until the power
is turned off after the no signal shut‑off function is executed; the message until the light source is turned off after the no signal lights‑out
function is executed
[MENU MODE]
Set the display mode of the menu screen (OSD).
1)
Press as to select [MENU MODE].
2)
Press qw to switch the item.
f The items will switch each time you press the button.
[NORMAL]
[SIMPLE]
Note
f For the menu items that are displayed when [SIMPLE] is set, refer to "Main menu" (x page 92), "Sub-menu" (x page 93).
[BACK COLOR]
Set the display of the projection screen when a signal is not input.
1)
Press as to select [BACK COLOR].
2)
Press qw to switch the item.
f The items will switch each time you press the button.
[BLUE]
[BLACK]
[DEFAULT LOGO]
[USER LOGO]
Note
f The [BACK COLOR] setting item is common with the following menu item.
g The [PROJECTOR SETUP] menu → [NO SIGNAL SETTING] → [BACK COLOR]
f To create and register the [USER LOGO] image, use "Logo Transfer Software". The software can be downloaded from the following website.
https://panasonic.net/cns/projector/
When transferring logos via the optional DIGITAL LINK output supported device (Model No.: ET-YFB100G, ET-YFB200G), setting for "NO
SIGNAL SLEEP" of the DIGITAL LINK output supported device should be set to "OFF" to avoid interruption of communication.
[STARTUP LOGO]
Set the logo display when the power is turned on.
1)
Press as to select [STARTUP LOGO].
2)
Press qw to switch the item.
f The items will switch each time you press the button.
[DEFAULT LOGO]
[USER LOGO]
[NONE]
Note
f When [USER LOGO] is selected, the display of the startup logo will be kept for approximately 15 seconds.
f To create and register the [USER LOGO] image, use "Logo Transfer Software". The software can be downloaded from the following website.
https://panasonic.net/cns/projector/
When transferring logos via the optional DIGITAL LINK output supported device (Model No.: ET-YFB100G, ET-YFB200G), setting for "NO
SIGNAL SLEEP" of the DIGITAL LINK output supported device should be set to "OFF" to avoid interruption of communication.
f When the [PROJECTOR SETUP] menu → [QUICK STARTUP] is set to [ON], the startup logo is not displayed when the projection is started
before the specified time has elapsed after going into the standby mode.
The specified time is the time set in the [PROJECTOR SETUP] menu → [QUICK STARTUP] → [VALID PERIOD].
Chapter 4 Settings — [DISPLAY OPTION] menu
Displays all menu items.
Displays some of the menu items that are used for basic setting or adjustment.
Displays blue in the entire projection screen.
Displays black in the entire projection screen.
Displays the Panasonic logo in the projection screen.
Displays the image registered by the user in the projection screen.
Displays the Panasonic logo.
Displays the image registered by the user.
Disables the startup logo display.
ENGLISH - 145
Advertisement
Table of Contents
