Remote Ui Set; Ethernet Driver - Canon lpb3360 User Manual

■ REMOTE UI SET.

■ ETHERNET DRIVER

■ INIT.N/W SET.
CONNECT.RECOG.
Downloaded from ManualsPrinter.com Manuals
REMOTE UI ..........................ON*, OFF
Specifies whether the printer should use the Remote UI.
AUTO DETECT.....................ON*, OFF
1
COMM.MODE* ....................HALF DUPLEX*, FULL DUPLEX
1
ETHERNET TYPE* .............10 BASE-T*, 100 BASE-TX
MAC ADDRESS....................(Display only)
*1 COMM.MODE and ETHERNET TYPE are displayed only when AUTO DETECT is set to OFF.
Configures the Ethernet driver.
NOTE
For more details on configuring the Ethernet driver, see "Chapter 2 Common
Network Settings" in Network Guide.
-
By the initialization in this item, you can reset the network settings to the default
settings.
The network settings can be initialized using the following procedure.
1.
Press the (Settings) key.
2.
Select INTERFACE MENU using [
3.
Select NETWORK MENU using [
4.
Select INIT.N/W SET. using [
5.
<OK?> is displayed. The initialization starts by pressing [OK].
* If you press the (Online) key without pressing [OK], the printer does not initialize the settings but
becomes ready to print.
NOTE
This item is displayed only when NETWORK in the I/F CONNECTION options is
set to ON.
ON*, OFF
When you print using a network, you may not obtain proper printout results
(Unreadable characters are printed, etc.). In this case, specify OFF for this item.
] and [ ], then press [OK].
] and [ ], then press [OK].
] and [ ], then press [OK].
SETUP Menu Settings
6
6-29