Main Body - Input Terminal - JVC DLA-RS40 Instruction Manual

1
Controls and features (continued)

Main body - Input terminal

④ RS-232C
① HDMI 1 Terminal
You can connect a device equipped with HDMI
output, etc. It is fitted to the M3 lock hole.
Screw hole depth 3mm. (Reference page: 26)
② HDMI 2 Terminal
You can connect a device equipped with HDMI
output, etc. It is fitted to the M3 lock hole.
Screw hole depth 3mm. (Reference page: 26)
③ LAN terminal "RJ-45"
This is a LAN-terminal. If one connects an
external PC, it is possible to control this unit by
sending control commands. (Reference page:
30)
④ RS-232C terminal (male D-Sub 9
pin)
This is a RS-232C interface standard terminal.
If one connects an external PC, it is possible to
control this unit. (Reference page: 29)
⑤ COMPONENT terminal "RCAx3"
It is also used as input terminal for analog
RGB (G on Sync) signals, component (Y, Cb,
Cr) signals, DTV format (Y, Pb, Pr) signals. It
can also be connected with devices, which are
equipped with signal output, etc. (Reference
page: 27)
Downloaded From projector-manual.com JVC Manuals
18
Getting started
① HDMI 1 ② HDMI 2
⑥ 3D SYNCHRO
RS50 RS50 RS60
③ LAN
RS50 RS50 RS60
⑦ PC
⑧ TRIGGER
RS50 RS50 RS60
⑥ 3D SYNCHRO terminal
3D synchro emitter: it is connected to the PK-
EM1 (sold separately) when enjoying 3D video
contents. (Reference page: 28)
⑦ PC terminal "D-Sub 15 pin"
This is an input term used for Personal Computer
(PC) signals only (RGB video signals and sync
signals). Use to connect a computer display
output terminal, etc. (Reference page: 28)
⑧ TRIGGER terminal(
DC power supply output terminal with DC12V,
100mA. It is used for output signals which control
the vacillating screen responding to the SCREEN
TRIGGER. Please note it can cause damage
to your equipment if the connection is done
incorrectly. (Tip = DC +12 V, Sleeve = GND)
(Reference Page: 29, 54)
⑨ REMOTE terminal to "Stereo mini
jack"
In case it is impossible to use the remote control
due to the installation of this unit's dedicated
BOX or rear projection, one can set up an
external light receiving section. It is used to
connect this external receiver and this unit. There
is no such product as an external light receptor.
Therefore, please consult your authorized JVC
service center. (Reference page: 30)
⑤ COMPONENT
⑨ REMOTE
RS50 RS50
)
RS60