Cleaning Area Rugs - Bissell CrossWave 1713 SERIES User Manual

Cleaning Area Rugs

NOTE: Before cleaning area rugs, test an inconspicuous area of the rug for
colorfastness. Also, please check manufacturer's tag before cleaning area rugs for
any specialised cleaning instructions. Not for use on silk or delicate area rugs.
NOTE: Before you begin, plug the machine into a properly grounded outlet.
1
3
Before each use, hold
the solution spray
trigger for 10 seconds to
prime the system with
cleaning solution. LED
lights illuminate when
holding the trigger.
NOTE: When solution
is flowing, you will see
bubbles forming at the
edges of the brush roll
window.
ATTENTION
Do not over wet carpet. Be careful not to run over loose objects or edges of area rugs.
Stalling the brush may result in premature belt failure.
8
www.BISSELL.com
Select
cleaning
mode:
To start cleaning your
area rugs, select the
RUG button to turn
the machine on in the
area rug setting. Once
selecting this setting,
the dry vacuum will
turn on. To turn OFF,
press the RUG setting
a second time.
NOTE: The RUG button dispenses twice the solution
of the HARD FLOOR button to help with area rug
cleaning.
4
To clean, hold the solution
spray trigger to apply
solution on both forward and
backward passes.
2
Recline the body of the machine
backward to start the brush roll spinning.
To stop the brush roll spinning, you will
need to stand the machine upright.
5
To dry area rugs faster,
run the machine over
your area rug without
holding the trigger.