HP ProLiant MicroServer Gen8 Maintenance And Service Manual page 53

CAUTION: Failure to completely open the processor locking lever prevents the processor from
seating during installation, leading to hardware damage.
CAUTION: THE PINS ON THE SYSTEM BOARD ARE VERY FRAGILE AND EASILY DAMAGED. To
avoid damage to the system board:
Do not touch the processor socket contacts.
•
Do not tilt or slide the processor when lowering the processor into the socket.
•
Install the processor. Use the notches on both sides of the processor to properly align it into the socket.
1.
CAUTION: Be sure to close the processor socket retaining bracket before closing the processor
locking lever. The lever should close without resistance. Forcing the lever closed can damage the
processor and socket, requiring system board replacement.
Close the processor retaining bracket, and then secure the processor locking lever.
2.
Clean the old thermal grease from the heatsink with the alcohol swab. Allow the alcohol to evaporate
3.
before continuing.
Removal and replacement procedures 53