Processor - HP ProLiant MicroServer Gen8 Maintenance And Service Manual

Press the Power On/Standby button.
8.
The server exits standby mode and applies full power to the system. The system power LED changes
from amber to green.

Processor

WARNING:
internal system components to cool before touching them.
CAUTION:
should attempt to replace or install the processor in this server.
IMPORTANT:
installing the processor.
To remove the component:
Power down the server (on page 24).
1.
Disconnect the power cord from the AC source.
2.
Disconnect the power cord from the server.
3.
Remove the chassis cover (on page 27).
4.
Remove the system board assembly (on page 29).
5.
Remove the heatsink ("Heatsink" on page 50).
6.
CAUTION:
especially the contact area.
CAUTION:
replacing the system board.
Open the processor locking lever, and then open the processor retaining bracket.
7.
Grasp the processor by the edges, and then lift it out of the socket.
8.
To replace the component:
To reduce the risk of personal injury from hot surfaces, allow the drives and the
To avoid damage to the processor and system board, only authorized personnel
If installing a processor with a faster speed, update the system ROM before
To avoid damage to the processor, do not touch the bottom of the processor,
The pins on the processor socket are very fragile. Any damage to them may require
Removal and replacement procedures 52