Changing A Wheel - Installing A Wheel; Tire Inflation - General Information - Volvo 2016 s60 inscription Owner's Manual

Changing a wheel – installing a wheel
It is important to re-install wheels properly.
Re-installing the wheel
1. Clean the contact surfaces on the wheel
and hub.
2. Lift the wheel and place it on the hub.
Tighten the wheel nuts
3. Install the wheel nuts and tighten hand-
tight. Using the lug wrench, tighten cross-
wise until all nuts are snug.
4. Lower the vehicle to the ground and alter-
nately tighten the bolts crosswise to
103 ft. lbs. (140 Nm).
5. Press the plastic covers onto the wheel
nuts and Install the wheel cover (where
applicable). The opening in the wheel
cover for the tire's inflation valve must be
positioned over the valve.
Related information
•
Changing a wheel – spare wheel (p. 254)
•
Changing a wheel – removing wheel
(p. 252)
09 Wheels and tires
Tire inflation – general information
Check tire inflation pressure regularly.
Inflation placard
Tire inflation placard
Tire inflation
See the tire inflation table in Tire inflation –
pressure table (p. 260). A tire inflation pres-
sure placard is also located on the driver's
side B-pillar (the structural member at the
side of the vehicle, at the rear of the driver's
door opening). This placard indicates the des-
ignation of the factory-mounted tires on your
vehicle, as well as load limits and inflation
pressure.
09
}}
255