Volvo 2016 s60 inscription Owner's Manual page 255

Lug wrench and towing eyelet
4. Screw the towing eyelet into the lug
wrench as shown in the illustration.
CAUTION
The towing eyelet must be screwed into
the lug wrench as far as possible.
5. With the vehicle still on the ground,
remove the plastic covers on the wheel
nuts with the tool provided and use the
lug wrench/towing eyelet to loosen the
wheel nuts ½ – 1 turn by exerting down-
ward (counterclockwise) pressure.
6. There are two jack attachment points on
each side of the vehicle. Position the jack
under the attachment point to be used on
a level, firm, non-slippery surface and
crank it up until it is correctly aligned and
seated in the attachment point. Before
raising the vehicle, check that the jack is
still correctly positioned in the attach-
ment.
7. Unscrew the wheel nuts completely and
remove the wheel.
09 Wheels and tires
WARNING
•
The jack must correctly engage the
jack attachment.
•
Be sure the jack is on a firm, level,
non-slippery surface.
•
Never allow any part of your body to
be extended under a vehicle suppor-
ted by a jack.
•
Use the jack intended for the vehicle
when changing a tire. For any other
job, use stands to support the vehicle.
•
Apply the parking brake and put the
gear selector in the Park (P) position.
•
Block the wheels standing on the
ground, use rigid wooden blocks or
large stones.
•
The jack should be kept well-greased
and clean, and should not be dam-
aged.
•
No objects should be placed between
the base of jack and the ground, or
between the jack and the attachment
bar on the vehicle.
09
}}
253