Flash Led Troubleshooting; Introduction To Flash Led Troubleshooting; Flash Led And Image Taking Conditions - Nokia n80 User Manual

Hide thumbs Also See for n80:
Table of Contents

Advertisement

RM-91; RM-92
Nokia Customer Care
Camera Module Troubleshooting

Flash LED troubleshooting

Introduction to flash LED troubleshooting

A fault or complaint associated to LED flash operation can be roughly categorized into two subgroups:
1 Flash is not functional at all (no light output at all).
2 Images can be taken and they are recognizable but for some reason the quality of images is degraded.
The quality of an image is very difficult to measure quantitatively, and even comparative measurements are
difficult (comparing two images), if the difference between reference images is small. If a user is not satisfied
with his/her device's image quality, it is fairly difficult to accurately test the device and get an exact result,
which would tell if the device is working properly.
Often subjective evaluation has to be used for finding out if there is something wrong in the flash. Some
training or experience of a correctly operating reference device may be needed in order to detect possible
faults. It is easy for a user to take low quality images in bad conditions. Therefore, the camera and flash
operation has to be always checked in constant conditions (lighting, temperature) or by using a second,
known-to-be good reference device.

Flash LED and image taking conditions

This section describes some of common factors, which may cause poor image quality if not taken into account
by end users when taking pictures, and may therefore result in complaints. The items described are normal
to the camera and LED flash operation and do not raise a need for servicing the components.
Figure 80 Example of a good quality image taken with the flash LED
Distance to the target (too close)
There is no feedback in the flash system, which means that the light output is constant in every situation.
This causes the images to overexposure, when shot from close distance. The flash LED is designed to work
optimally between distances of 70 cm – 1.2 m.
Page 8 –24
COMPANY CONFIDENTIAL
Issue 1
Copyright © 2006 Nokia. All rights reserved.

Advertisement

Table of Contents

Troubleshooting

loading

This manual is also suitable for:

Rm-91Rm-92

Table of Contents