Suzuki VS700 Service Manual page 524

26-02 VS800K8 ('08 MODEL)
WIRING HARNESS ROUTING
To right handlebar
switch
To left handlebar
switch
To the meter
Wiring harness
Handlebar switch (R & L)
Cut after clamping.
To horn
Fan motor
Pass the generator lead wire and
neutral switch lead wire between
the crankcase and secondary
case cover.
Clamp
Tail/Brake lamp switch
Battery -
Battery -
Newtral switch
Clamp
Coupler holder
Clamp
Wiring
harness
High-tension cord
Pass the wiring harness
inside of the throttle cable.
Wiring harness, speedometer
Handlebar switch (R & L)
Clutch hose
Clamp
Clamp
Pass the ignition coil
lead wire inside of regulator
lead wire. (Except E-33)
Pipe
For E-33
Pass the handlebar switch
lead wire hole of the upper
bracket.
Clamp
Wiring harness
I.g. switch
lead wire
To fan
I.g. switch
motor
Clamp
Frame
To side stand
Clamp
switch
Front
Side stand switch
Clamp Clamp
Wiring harness
Tail/Brake light
Battery - lead wire
Ignition coil lead wire
Ignitor
Wiring harness
Clamp
Pass the starter motor
lead wire as shown.
OK NG
Clamp the throttle
position switch lead wire.
* Throttle position switch
Fuel hose
Starter relay
I.g. coil
Generator
lead wire
Battery -
terminal
To regulator/
rectifier
Generator
Neutral switch
Clamp
Tail/Brake light
License plate light
Rear turn signal light (R & L)
To rear turn
signal light (R)
Slit is
lower side.
Face the small
lip of grommet
to the outside.
To rear turn
signal light (L)
Set the lead wire
clamp securely.
Backside of the seat
Side stand relay
Pass the regulator/rectifier
lead wire between the fuse
box and starter relay.
Pass the lead wires
inside the frame.
Regulator/Rectifier
Neutral indicator light switch
Battery - and +
lead wire
Starter motor
Clamp
–
2.5 4.0 mm