Wiring Harness Routing - Suzuki VS700 Service Manual

WIRING HARNESS ROUTING

To right handlebar
switch
To left handlebar
switch
To the meter
Wiring harness
Handlebar switch (R & L)
Cut after clamping.
To horn
Fan motor
Clamp the lead wire so as not to
touch it between the secondary
cover and crankcase.
Clamp
Tail/Brake lamp switch
Battery
Battery
Newtral switch
Clamp
Coupler holder
Clamp
Wiring
harness
High-tension cord
Pass harness inside
of the throttle cable
Wiring harness, speedometer
Handlebar switch (R & L)
Clutch hose
Clamp
Clamp
Pass the ignition coil
lead wire inside of regulator
lead wire. (Except E-33)
Pipe
For E-33
Pass the lead wire
hole of the upper bracket.
Clamp
Wiring harness
I.g. switch
lead wire
To fan
I.g. switch
motor
Clamp
Frame
To side stand switch
Clamp
Front
Clamp
Wiring harness
Tail/Brake light
Battery lead wire
Ignition coil lead wire
Wiring harness
Clamp
Set parallel the starter
lead wire with the motor.
Clamp the throttle
position switch lead wire.
* Throttle position switch
Fuel hose
I.g. coil
Generator
lead wire
Battery
terminal
To regulator/
rectifier
Side stand switch
Clamp
Tail/Brake light
License plate light
Rear turn signal light (R & L)
To rear turn
signal light (R)
Ignitor
To rear turn
signal light (L)
Squash flats
after clamp.
Backside of the seat
Side stand relay
Starter relay
Pass the regulator/rectifier
lead wire between the fuse
box and starter relay.
Pass the neutral switch and
battery lead wire to the
frame right side.
Regulator/Rectifier
Neutral indicator light switch +
Battery and
lead wire
Starter motor
Clamp
Pass the all lead wire
inside of frame.
–
2.5 4.0 mm
Slit is
lower side.
Small lip
is outside.