Advertisement
Installations
Be sure to read "Precautions" before installation. The Installation Guide of the camera shall be read
as well.
1.
Put Template A (accessory) against the
ceiling and make a hole.
1
Make 4 holes of 12 mm {1/2"} in diameter.
2
Remove the center part from the tem-
plate.
3
Make a hole of 220 mm {8-43/64"} in
diameter.
Ceiling face
Template A
2.
Install two anchor bolts (M10 recommended) into the concrete ceiling.
1
Determine the anchor bolt length by use of Template B (accessory).
2
Position the nut by use of Template B (accessory). (The distance between the bottom sur-
faces of the ceiling board and nut shall be 169 mm {6-21/32"}.)
Anchor bolt
Template B
Ceiling board
Note: If there is already an anchor bolt installed, the anchor bolt can be used as a second
anchor bolt. Make sure that the distance between the 1st and 2nd anchor bolts is 1 000
mm {39-3/8"} or less before use.
ø12 mm {1/2"}
(4 positions)
ø220 mm
{8-43/64"}
Install the anchor bolt in the center of the hole
* 1 The hole shape is shown below.
* 2 [For those concerned with the direction of
the brand logo]
In order to set the position of the brand
logo on the decorative cover you installed
in Step 14 at the 12 mm hole, you must
perform the required operations during
Step 1.
Perform Step 1 to make sure the desired
brand logo direction matches the "Brand
logo side" setting on Template A. Also
pay attention to this setting when per-
forming Step 6 later.
Use a nut
Determine the anchor bolt length
169 mm {6-21/32"}
5
Advertisement
