Saeco HD8854 Operating Instructions Manual page 47

42
maCHIne WarnInGS
Help Message Displayed
TURN CARAFE
INTO
BREWING POSITION
TURN CARAFE
INTO
RINSING POSITION
INSERT CARAFE
RESTART TO SOLVE
Downloaded from CoffeeMachineManual.com Manuals
How to Reset the Message
A beverage with milk has been selected. The machine requires the carafe handle
spout to be placed into dispensing position.
Press the button "ESC" to cancel the selection.
ESC
The carafe rinse function has been selected.
Press the button "ESC" to cancel the selection.
ESC
The selected operation requires the milk container for brewing. Insert the container
in the machine as specified in the manual.
ESC Press the button "ESC" to cancel the selection.
Perform a descaling cycle on the machine.
When this message is displayed, it is still possible to use the machine, but its correct
operation might be compromised.
Damages caused by failure to descale the machine are not covered by warranty.
The machine requests the "Intenza" water filter to be replaced with a new one.
Replace the filter as described on page 7.
The alarm is displayed only if the "Enable Filter" function is set to "ON".
(See page 28).
Flashing red light. Machine in Stand-by.
The Stand-by settings can be changed.
Press the "
An event has occurred which requires the machine restart.
Take note of the code (E xx) shown at the bottom.
Switch off the machine, wait 30 seconds and then switch it on again. If the problem
persists, contact the service centre.
" button.