Table of Contents
Advertisement
Fuel Tank Filter
CONNECTOR
5 mm SCREWS (4)
GASKET
FUEL TANK
FILLER
FUEL TANK FILTER JOINT
(Fuel Hose Connector)
1. Remove the four 5 mm screws
using a flat screwdriver, then
remove the fuel hose connector and
fuel tank filter from the tank.
2. Clean the filter in nonflammable
solvent. Inspect the fuel tank filter
and the connector gasket. Replace
them if damaged.
3. Reinstall the filter and hose
connector in the fuel tank. Tighten
the four 5 mm screws securely.
SERVICING YOUR OUTBOARD MOTOR
Anode Replacement
ANODE
(stern bracket)
The anodes are located on each side
of the gear case and on the stern
bracket. They are made of a
sacrificial material that helps to
protect the outboard motor from
corrosion.
Replace the anodes when they have
been reduced to about half their
original size, or if they are crumbling.
ANODE
(each side)
Painting or coating the anodes will
def eat their purpose and will lead to
rust and corrosion damage to the
outboard motor. The anodes must be
exposed to the water in order to
protect the outboard motor.
91
Advertisement
Table of Contents
