Table of Contents
Advertisement
®
ENFORCER
Appendix 1 — UNDERSTANDING THE
SIREN CHIRPS AND LIGHT FLASHES
A. 1 chirp/flash:
When the Lock button is pressed, the
alarm is armed.
When a door is closed, the alarm will
arm in 30 sec. (passive arming).
30 sec. after ignition switch is turned
OFF and all doors are closed (or
delayed domelights turn OFF), the
alarm is armed (passive arming).
Successfully entered the valet mode.
B. 2 chirps/flashes:
When the Unlock button is pressed, the
alarm is disarmed. (After the two
flashes, the parking lights turn steady
ON for 6 sec.)
Successfully exited the valet mode.
C. 3 chirps/flashes:
Pre-intrusion warns potential thieves or
vandals who trigger the first stage of
any dual-stage sensor that your car is
protected by an alarm.
When pressing the Lock button to arm
the alarm, indicates the alarm arms
even though it is not set properly (door
Page 10
SLI 840/840C Owner's Manual
not closed, or broken switch, or
domelight is still ON, see ZONE BYPASS
on page 5).
When pressing the Lock button
followed by the Auxiliary (*) button,
indicates sensor bypassed (see SENSOR
BYPASS on page 5).
Completed emergency disarm.
D. 4 chirps/flashes:
When the alarm is disarmed, indicates
the alarm was triggered while you were
away.
When the Lock or Unlock button is
pressed, indicates the alarm in valet
(flashes only, no chirps).
NOTE — The chirps for arm, disarm, pre-
intrusion, zone bypass, sensor bypass,
emergency disarm, valet, and tamper can be
deleted (see CHIRP DELETE, page 7).
SECO-LARM U.S.A., Inc.
Advertisement
Table of Contents
